Unit 1, 10 Duerdin St, Clayton VIC 3168, Australia
Tel: +61 3 9239 8088 Fax: +61 3 9239 8024
E-mail: [email protected] www.clenergy.com.au
15
page
of 17
Installation Guide_PV-ezRack ComT V2.0 (September 2020)
Installation Instruction
5.5.1 Place the PV Modules on the Front and
Rear Leg as shown Figure 21. The outside
edge of the frame of the PV Modules must
overlap the marking lines on the Front and
Rear Legs as shown in Figure 22. The pins
of Front and Rear legs are used for creating
earthing continuity from PV modules to both
legs.
5.5.2 Fix the clamp on the Rear Leg shown in
Figure 23 and fasten the clamps of Front and
Rear legs till the PV Modules are properly
installed in Figure 24.
Recommended torques:
M8 Bolt:16-20N·m
5.5.3 Repeat the above steps to install other
Front and Rear Legs, and PV modules.
Figure 21
Figure 22
Figure 23
Figure 24
5.5 PV Module Installation
