PULSAR
®
PLUS 55-S SUCTION BLAST CABINET
Page 29
© 2021 CLEMCO INDUSTRIES CORP.
www.clemcoindustries.com
Manual No. 30423
7.10.3
After installing the O-ring, place the part against
the one next to it, making sure the flanges on the parts fit
into the recess on the bracket, as shown in Figure 39.
7.10.4
Press the parts together and insert the retaining
clip over the mounting flanges and torque the screws to
1.2 N m (10.6 lbf in).
Figure 39
7.11
Replacing Reclaimer Wear Plate
To access wear-plate mounting screws, the
reclaimer must be removed from the power
module. Pulsar reclaimers weigh about 100 lbs.
When removing and installing the reclaimer, it
must be adequately supported and secured to
appropriate lift equipment. Failure to secure
and use proper lift device can result in injury.
Installation Notes:
Make sure an inlet-pipe gasket,
Stock No. 11746, is available to replace a compressed
or damaged gaskets on the reclaimer inlet.
7.11.1
Remove the flex hose from the reclaimer inlet.
7.11.2
Remove the reclaimer inlet-pipe adaptor,
adaptor gasket, and old wear plate. The wear plate is
held in place by screws attached from the outside of the
reclaimer. Remove the screws and pull out the wear
plate through the reclaimer inlet.
7.11.3
Remove remnants of old caulk that will prevent
the new wear plate from seating against the reclaimer
wall and top.
7.11.4
Angle the new wear plate into the reclaimer inlet
and position it so the straight end is flush with the inlet.
Use locking pliers, clamps, or other means to hold the
wear plate in position, making sure the leading edge of
the wear plate is aligned with the reclaimer inlet and that
the top edge is even with the top of the reclaimer.
Figure 40
7.11.5
Install the front-two sheet metal screws through
the old screw holes to secure.
7.11.6
Use a board or similar object as leverage to pry
the wear plate against the inner wall of the reclaimer, as
shown in Figure 40.
7.11.7
New self-drilling sheet metal screws are
provided with the wear plate. While forcing the wear
plate against the reclaimer wall, install the screws
through the remaining screw holes to secure. Rearrange
the pry board as needed to press the wear plate against
the reclaimer wall when installing screws.
7.11.8
To avoid rapid wear, apply RTV caulk to fill gaps
at the seams on the top, bottom, and leading edge of the
wear plate
7.11.9
Use a new inlet gasket and reattach the inlet-
pipe adaptor.
7.11.10
Connect the flex hose to the inlet pipe adaptor.
7.11.11
Allow time for the caulking to cure before
putting the reclaimer into service.
Align leading edge and
clamp where needed.
Use board to pry back of wear plate against
reclaimer wall and then install screws.
Screws
Wear Plate
Mounting Flanges
Bracket Recess
Torque screws to 10.6 lbf in.