PULSAR
®
PLUS 55-S SUCTION BLAST CABINET
Page 25
© 2021 CLEMCO INDUSTRIES CORP.
www.clemcoindustries.com
Manual No. 30423
Figure 32
7.2.3
Unlock the glove mounts and gloves from the
attachment rings by turning them counterclockwise.
7.2.4
Remove the glove mount and glove from the
cabinet by pulling the gloves through the glove ports.
7.2.5
To reattach the glove mount and glove, place
arms into the replacement gloves and insert both gloves
through both glove ports.
7.2.6
Align the slots in the glove mount with the
shoulder screw heads on the attachment ring, push in on
the glove mount, and then turn it clockwise to lock it.
7.3
BNP
®
Gun Assembly ‒ Figure 33
7.3.1
Replace the nozzle when its orifice diameter has
worn 1/16" larger than its original size or when suction
diminishes noticeably. To change the nozzle, unscrew
the holding nut from the gun end and pull the nozzle
from the gun. Inspect the nozzle O-ring and replace if
worn or damaged. Insert a new O-ring and nozzle,
placing the tapered end toward the jet. Screw the
holding nut onto the gun.
Figure 33
7.4
View-Window Cover Lens
7.4.1
Rapid frosting of the view window can be
avoided by directing ricocheting media away from the
window and by installing a cover lens on the inside
surface of the window. Using cover lenses prolongs the
life of the view window.
7.4.2
The best way to install a cover lens is to remove
the window from the cabinet. If, for some reason, it is not
practical to remove the window, the lens may be applied
with the window glass in place.
7.4.3
To install a cover lens, carefully remove the
adhesive backing making sure the adhesive remains on
the lens, and apply the lens to the clean, dry inner
surface of the view window. When the cover lens
becomes pitted or frosted, replace it.
7.5
View-Window Replacement
Do not use plate glass for replacement view
windows. Plate glass shatters on impact and
can cause severe injury. Use only genuine
ZERO
®
laminated replacement glass.
7.5.1
Remove the two window-frame nuts located on
the upper edge of the window frame and swing the
window frame open. If the frame is to remain open, for
cleaning or other reasons, remove it, per Section 7.7.
7.5.2
Remove the old window.
7.5.3
Inspect the window-frame gaskets on both the
window frame and on the cabinet. If either gasket is
damaged, replace it, per section 7.6.
The wider, tapered
end of the nozzle
inserts into the gun.
Wide End
O-Ring
Media Hose
Air Jet Cover
Nozzle
Nozzle Holding Nut
Air Hose
Mounting screws and slots as viewed from outside of the cabinet.
Mounting screws and slots as viewed from inside of the cabinet.
Shoulder Screw Head
Shoulder Screw Slot
Shoulder Screw Slot
Shoulder Screw Head
Armrest-Glove Mount
Attachment Ring
Armrest-
Glove Mount
Glove Mount Attachment Ring