BNP DOUBLE 65 and DOUBLE 220 - DUAL STATION SUCTION CABINET
Page 8
© 2016 CLEMCO INDUSTRIES CORP.
www.clemcoindustries.com
Manual No. 22963 Rev. D, 07/16
3.3 Manometer
The optional manometer kit is listed in Section 9.1.
3.3.1
Consistent static pressure is necessary for
precise media separation, as the reclaimer's efficiency is
achieved by a centrifugal balance of air flow, particle
weight, and size. The manometer measures static
pressure. Reclaimer static pressure is set by adjusting
the dust collector ventilation-damper. Refer to Section
5.4 to adjust static pressure. Refer to Section 5.8 for
instructions on using the manometer.
3.4 Armrest
3.4.1
Assemble the armrest and mounting brackets as
shown in Figure 9.
3.4.2
Position the assembly so the armrest is about
even with the bottom of the arm-port opening. Mark one
hole location on the front of the cabinet at each
mounting bracket.
Figure
9
3.4.3
Drill a 3/8" hole at both locations and mount the
armrest using 5/16 cap screw, washers and nuts. Install
the bolts from inside the cabinet to protect the threads
from abrasion, should the armrest need to be removed
at a later date.
3.4.4
Match drill the remaining four bracket holes and
install the remaining fasteners.
3.4.5
Loosen the fasteners on the slotted bracket and
raise or lower the armrest to a comfortable position.
3.5
Turntable with Workcar and Track
3.5.1
Components of the turntable and track assembly
are shown in Figure 10. The assembly consists of:
1. The inside track assembly, which is placed inside
the cabinet.
2. The hinged track extension attaches to the support
table, swings up to clear the door.
3. The track support table.
4. Turntable and workcar assembly.
Figure 10
NOTE: The track may be placed on either side of the
cabinet, allowing entry through either door. When
installing the inside track, place it so the stops are
opposite the entry door.
3.5.2
Place the inside track in the cabinet over the
existing grate as shown in Figure 11.
3.5.3
Position the track support table and extension
as shown in Figure 12. When the hinged extension is
lowered, the extension tracks must rest on the angled
locating supports welded to the bottom of the inside
tracks, and butt against the inside tracks.
Figure 11
Inside Track
Hinged Track Extension
Track Support Table
Turntable and
Workcar
5/16 x 1" x Cap Screw,
Flat Washer, Lock
Washer and Nut
Stops
Entry Door
Armrest
Grate
3/8 x 1" Cap Screw
and Lock Washer
