OPERATION
26
Tennant T500 (01-2017)
VIDEO TUTORIAL BUTTON
(Operator Mode Home Screen)
Press the video tutorial button to access the video
tutorial screen (Figure 63). It includes videos on how to
perform specific operation and maintenance
procedures. Press the video buttons to start video.
Press the rotate button for additional videos. The lower
right video button provides a list of additional tutorial
videos.
FIG. 63
PRESET ZONE CONTROL BUTTONS
Use the zone control buttons to preset up to four zones
with different solution flow rates, brush pressing, scrub
speeds and scrub modes (Figure 64).
The four zone control buttons are factory preset for
different scrubbing applications. The zone control
button will turn green when zone is activated.
FIG. 64
To preset the zone control buttons for different
scrubbing applications:
NOTE: Only the supervisor mode has the capability
to change the factory zone settings (See
SUPERVISOR CONTROLS instructions at back of
manual).
1. Select the desired settings from list below,
- Brush pressure rate
- Solution flow rate
- Quiet-Mode on or off
- ec-H2O system on or off (option)
- Severe Environment mode on or off (option)
- Maximum scrub speed
NOTE: The severe environment mode and ec-H2O
system cannot be preset together.
2. Then press and hold a zone button until a screen
prompts you to name the new preset zone. Select
“yes” to name the preset zone (Figure 65).
FIG. 65
3. If the zone settings are configured to scrub a lobby
for example, name the zone “LOBBY” (Figure 66).
Press the green arrow to save the new zone
preset.
FIG. 66
4. The name will appear above the zone setting
number when the zone button is pressed (Figure
67). Repeat process for other zone presets.
FIG. 67
