25
26
Removing Booster Seat in Full Back Mode
When Using LATCH Connectors
Step 1.
Pull on the Recline Handle located on the front of the
booster Seat Base and slide this booster seat towards
you exposing the LATCH Connectors
1
, as shown
in
Figure 22
.
Step 2.
Locate the red buttons on the front of the LATCH Connectors.
Releasing one LATCH connector at a time, use your thumb
to press in on one button
2
while using the other hand to
pull this booster seat forward
3
, as shown in
Figure 23
.
Repeat for the opposite LATCH connector.
To store the LATCH Connectors when not in use, pull and
hold Recline Handle on front of booster Seat Base and
then push LATCH Connectors into Seat Base.
Step 3.
Remove this booster seat from vehicle.
Figure 23
2
3
Figure 22
1
Installing Booster Seat in Backless Mode
When Using Latch Connectors
To remove Seat Back, see “Installing/Removing Seat Back”
section on page 53.
Step 1.
Select a forward-facing vehicle seating location which has
a lap and shoulder belt and LATCH Anchorage System.
If the vehicle seat back is adjustable, make sure the seat
back is locked in the upright position. DO NOT allow the
child to sit in this booster seat while the vehicle seat back
is reclined, as shown in
Figure 24
.
Figure 24
WARNING
• WHEN IN BACKLESS MODE, THE BACK OF THIS BOOSTER SEAT BASE MUST
CONTACT THE VEHICLE SEAT BACK.
