21
22
IMPORTANT:
If LATCH Connectors fail to connect to the vehicle’s LATCH lower anchors,
you can still use this seat. See “Installing Booster Seat in Full Back Mode WITHOUT Using
LATCH Connectors” section of this manual on page 34.
Please notify Clek Customer
Service if the LATCH Connectors fail to latch by calling 1-866-656-2462.
Step 3.
Once the LATCH Connectors are connected to the LATCH lower anchors, pull forward on
this booster seat to make sure it is securely attached to the vehicle’s LATCH lower anchors
on both sides. If not, start over at
Step 1
.
Step 4.
Complete installation by adjusting this booster seat so the back of this booster seat
contacts the front of the vehicle seat back or headrest, as shown in
Figure 16
.
To adjust, pull and hold the Recline Handle
on the front of the booster Seat Base
1
and push the booster Seat Back towards
the vehicle’s seat back
2
until the back of
this booster seat sits firmly against the
vehicle seat back, as shown in
Figure 17
.
Release Recline Handle.
Ensure that the booster seat Headrest is in
contact with the front surface of the vehicle
seat back or headrest. DO NOT allow a
gap between the booster seat Headrest
and the vehicle seat back or headrest,
as shown in
Figure 18
. A gap between
the booster Seat Base and the vehicle seat
back is acceptable when being used in
the full back mode.
Figure 16
Figure 17
1
2
Figure 18
