Apex Tool Group
P2544PM | 2021-02
51
5
EN
P2381TS
.
EMS errors are errors sent by the measuring board. See Document
P2381TS
.
Problem
Possible cause
Measure
Bluetooth data communication between controller and tool
The tool can not connect
with the controller.
Controller is not visible.
Make sure that the Bluetooth function is
activated on the controller.
The controller is not dis-
played in the
Scanning
Bluetooth devices
menu.
Make sure that the Bluetooth function is
activated on the controller.
Check that the controller is visible with
another tool.
Establishing a Bluetooth
connection fails.
Note that the tool can only connect to an
mPro200GC series controller.
Retry to establish a Bluetooth connection.
Restart the tool and try to establish the
Bluetooth connection again.
Restart the controller and try to establish
the Bluetooth connection again.
The node number is
assigned twice.
Make sure that each node number is
assigned only once. Note that only seven
nodes are possible.
The wrong IP address is
used for the tool on the
controller.
Make sure that the tool has been installed
on the controller with the correct IP
address.
