CLEARSPAN
™
GREENHOUSES
26
Revision date: 07.29.14
ASSEMBLE AND ATTACH SLIDING DOORS (continued)
7. Verify that the marks for the sliding door track are level
and attach the two sections of door track to the end
wall frame.
NOTE:
The track must be level for the doors to function
properly.
INSTALL SLIDING DOORS
Complete the following steps to properly attach the sliding
door track mounts to the end wall frame of the greenhouse.
1. Locate the 3/8" x 4" carriage bolts and related nuts and
washers used to secure the track brackets to the end
wall framing.
2. After identifying and marking the desired height of the
door track on the end wall, determine the locations of
the track brackets.
The dashed line above represents the sliding door
track. The arrows show where to attach the track
brackets to the end wall framing.
3. Drill a 3/8" hole through the corrugated polycarbonate
panel and through the vertical end wall frame tube.
The hole must be level to mount the bracket and track
properly
.
4. Insert a 3/8" carriage bolts through a hole from inside
the building and tap it with a hammer to set it tight
against the end wall frame member.
Install a flat washer,
lock washer and nut to
secure the mounting
bolt to the end wall
frame.
Cut if desired
5. Repeat the steps to install the remaining sliding track
mounting bolts. All mounting bolts must be installed at
the same height on the end wall frame so that the track
is level.
6. After installing the mounting bolts, slide the two track
mounting brackets onto the sliding door track.
7. Align the brackets with the mounting bolts and install a
flat washer, lock washer, and a nut.
8. Verify that the track is level and flush to the inside edge
of the end rafter and tighten the 3/8" nuts. The carriage
bolts can be trimmed if desired.
NOTE:
The center track mounting bracket will cover
the joint where the separate track sections meet at the
center of the end wall.
9. After securing the track to the end wall frame, lift one
door up and into place and insert the rollers into the
track.
10. Repeat the step to install the second door into the
track.
11. Slide both doors to the center of the door opening to
the closed position and adjust as needed to level the
doors so they meet evenly at the center.
12. Adjust the lower stay rollers as needed.
