10
Tips and Help Guide
(Simple preventative measures and tips for all new users of the Farrow System)
DO NOT ADJUST ANYTHING INSIDE THE MACHINE
WITHOUT PROPER TRAINING OR CALLING TECH
SUPPORT FIRST!
1-888-327-7698 or [email protected]
Suggested settings to get you started:
45psi blast pressure—abrasive dose: 1/2 turn open
65psi blast pressure—abrasive dose 1 turn open
80+psi blast pressure—abrasive dose 2 turns open
Pneumatic trigger (deadman trigger) will not be live until the system is in
Blast Mode and the pot is pressurized.
Never load dry media into the blast pot without at least putting one-two
gallons of water in first. This equates to running the Wash Hose or
Pressurize mode for about 30 seconds prior to adding media.
Do not place or allow any foreign material in the blast pot.
Be sure to use your blast pot lid when the machine is not being used to
prevent objects such as leafs, sticks and rocks from getting in and
causing the system to clog. Also be cautious when pouring media into
the pot that portions of the bag do not rip and fall inside.
When blasting vertically higher than 10ft. above the machine, be sure to
leave 10%-20% of the total length of hose on the ground in front of
machine before running hose vertically. For more information see
“Blasting at Elevation” page.
Never pull blast hose at a 90 degree angle around corners and
especially at the connection to the panel! This will cause the blast hose to
wear quickly and burn a hole through the hose wall at the bend.
If you have any questions or troubleshooting needs, call your local tech
support for help.
