24 CV1450/1700/1950 Installation Guide
© Clear Vue Cyclones 2022
Installing Your Power Box
1. Wire the pigtail to the motor. For instructions, refer to the section on “Electrical – Single Phase
Motors”.
a. The blue (#1) and black (#5) wires on the motor connect to the black wire on the pigtail.
b. The red (#8) and black (#4) wires on the motor connect to the white wire on the pigtail.
c. The green wire on the pigtail is grounded to the motor.
You are wiring according to the Opposite Standard configuration graphic found on the
body of the motor, referenced to the right.
2. Open the cover of the Power Box by loosening the (4) screws that secure it in place and slide the
cover up and then off.
3. Secure the Power Box to your wall using the (4) pre-drilled holes on the back of the box (hardware
not included).
4. Hardwire the 220v power from your panel to the relay inside the box, using the knockout opening
on the top of the box:
a. Secure the hot leads – one each – to each of the terminal pins on the top of the relay.
Please note the leads are interchangeable.
b. Secure the ground wire into the top position on the grounding bar.
5. Install the 110v receiver:
a. Plug the receiver into the 110v outlet on the side of the box.
b. Plug the 110v power cord from the top of the box into the side of the receiver.
c. Plug the 110v power cord from the bottom to a separate 110v Outlet.
6. Plug the pigtail from your motor into the 3-wire 230v outlet on the side of the box.
