EN
20
Attaching / Detaching the Brush and Crevice Nozzle
• Plug the nozzle you want into the suction opening (
13
) or the extension tube (
H
). The
nozzle must engage audibly.
• To detach it, press the release button (
13
) above the suction opening and pull the
nozzle out at the same time.
Removing / Inserting the Dust Container
• Removing: Press the release button (
14
) on the front of the dust container (
3
) and pull
the dust container upwards to remove it.
• Inserting: Insert the dust container into the motor unit (
F
) from above. When you do
this, make sure that the release button is pointing downwards (towards the motor
unit) (
Picture A
). The dust container must engage audibly.
Operation
PLEASE NOTE!
■
Ensure that there are no larger, sharp objects on the surface which is to be cleaned.
■
Note the
MAX
marking on the dust container. If during use the marking is reached,
empty the dust container. Empty and clean the dust container after each use. The
fi
lters must also be regularly cleaned in order to prevent overloading of the motor.
■
Switch the device o
ff
after each surface has been cleaned as this will considerably
increase the operating time on each battery charge. Charge up the battery after use
(see the "Charging Up the Battery" chapter).
1. Select an accessory as required (see the "Accessories" chapter) and attach it to the
device (see the "Assembly" chapter).
2. Switch on the device by pressing the On / O
ff
switch (
9
) once. The device will start
vacuuming immediately. The Level I operating lamp (
7
) lights up.
3. If necessary, Level II can be switched on with the
I / II
button (
8
). The Level I and II
operating lamps light up. To switch back to Level I, press the
I / II
button again.
4. Move the device over the surface to be cleaned.
5. If the device is to be switched o
ff
again, press the On / O
ff
switch again.
6. To ensure optimum performance of the device, empty and if necessary clean the dust
container (
3
) after every use (see next chapter).
05980_inlay_de-en-fr-nl_A5_V1.indb 20
05980_inlay_de-en-fr-nl_A5_V1.indb 20
20.01.2020 10:24:46
20.01.2020 10:24:46
