EN
16
•
To attach the required accessory, fol
low the instructions in the “Attaching
and Detaching Accessories” chapter.
•
Make sure that the fresh water
tank (
13
) is filled (see the “Filling the
Fresh Water Tank” chapter) and both
tanks are inserted in the motor unit (
4
).
•
If there is a lot of dirt, first spray
cleaning agent onto the surface to
be cleaned and spread it around with
a brush if necessary. It is essential to
follow the instructions on the bottle of
the cleaning agent.
1. Fully unwind the connecting cable and
plug the mains plug into a plug socket.
2. Press the
button (
2
) to switch on
the device.
3. Press the spray button (
8
) on the bot
tom of the handle and spray onto the
surface to be cleaned.
4. Pull the nozzle opening with gen
tle pressure over the surface to be
cleaned. The dirty water is sucked
up and collected in the dirty water
tank (
16
).
5. When the fresh water tank is empty
or the dirty water tank is full, press
the
button to switch off the
device.
Only after this
should you fill
or empty the appropriate tank (see
the “Cleaning the Device” chapter –
“Dirty Water Tank”).
L
Place the nozzle on a cloth as
residual water may escape after it
has been switched off.
6. After it has been used, empty the
fresh water tank and reinsert it in
the device. Switch on the device
again and press the spray button to
remove excess water from the device
(
Picture D
).
7. Press the
button to switch off the
device and pull the mains plug out of
the plug socket.
8. After every use, fully empty and clean
the tanks (see the “Cleaning the De
vice” chapter).
CLEANING THE DEVICE
Please Note!
■
Make sure that no liquid gets into
the motor unit of the device during
cleaning.
■
Do not use any sharp or abrasive
cleaning agents to clean the device
and accessories.
•
Wipe down the motor unit (
4
) if nec
essary with a damp soft cloth. Then
dry with a cloth.
•
The filters are located in the motor
unit beneath the dirty water tank
(
Picture E
) and beneath the fresh
water tank (
Picture F
). They can be
removed for cleaning and rinsed
through with clear water. Then allow
them to dry in the air.
Dirty Water Tank
1. Detach the dirty water tank (
16
) from
the motor unit (
4
) and open it (see the
“Attaching and Detaching Accessories”
chapter – “Dirty Water Tank”).
2. Empty the water into a drain.
3. To clean it, thoroughly rinse the dirty
water tank and the lid with clear water.
4. Allow all parts to dry open in the air
before you reassemble them.
Fresh Water Tank
1. Detach the fresh water tank (
13
) and
open it (see the “Attaching and De
taching Accessories” chapter – “Fresh
Water Tank”).
2. Fully empty the fresh water tank.
3. Allow all parts to dry open in the air
before you reassemble them.
Summary of Contents for 04982
Page 2: ...B B F F E E A 2 1 17 16 4 5 13 15 3 6 7 8 9 10 11 12 14 18 C C D D...
Page 40: ......
Page 41: ......
Page 42: ......
