18
Cleanfix —KS 1100—simply clean
Readjustment of the Cylindrical brush
Sweeping height / Sweeping range
The sweeping height/sweeping range of the
cylindrical brush is important to achieve per-
fect surface cleaning results and for the most
effective use of the cylindrical brush.
Checking the sweeping height/range:
Drive the Ride-on-Sweeper on a surface
requiring cleaning. Switch-ON the cylindrical
brush motor but do not drive onwards. Let
the cylindrical brush work 1-2 minutes in
standing position. Now lift the lever of the
cylindrical brush. Switch-OFF the cylindrical
brush motor and drive a few metres forward.
The sweep track left behind on the floor is
the Sweeping range.
Test-Cleaning
•
Keep the safety cover closed
•
Take a piece of chalk and draw a line on
the floor starting inbetween both side brus-
hes (centre-line) and leading a few metres
ahead of the machine.
•
Lift-up the cylindrical brush and drive slowly
towards the chalk line and then park the
machine above this chalk line.
•
As soon as the sweeper stands on top of
the chalk line, lower the cylindrical brush
(release the lever and lead downwards)
•
Switch ON the motor for the cylindrical
brush and start cleaning. The cylindrical
brush should clean about 2 cm
Adjustment of the Sweeping height/
Sweeping range
•
Switch-OFF the Ride-on-Sweeper
•
Pull the lever upwards which lifts the
cylindrical brush
•
Open the main cover of the machine
•
Secure the main cover in open-position by
using the support rod
•
Now remove the side cover of the machine,
which is on the right-hand side when
looking in driving direction.
Further adjustment possibilities:
•
Remove the side cover of the machine on
the right hand side (driving direction view)
•
Release the clamping screw
•
Put the cylindrical brush-support sheet
metal into the correct position
•
Refasten the clamping screw and re-
mount the side cover of the machine.
Reference note:
Original diameter of the
Cylindrical Brush:
290mm
The brush must be replaced
when the diameter is below:
250 mm
Nut
Counter nut
Thread rod
The suitable key for the height
Adjustment of the cylindrical
brush.
15
Cleanfix —KS 1100—simply clean
Maintenance and Service
Attention!
Before doing any work on the Ride-on-Sweeper it is compulsory to first
TURN-OFF and the Main Switch (Emergency-Off Switch) and REMOVE
THE KEY in order to prevent unforeseen switching-on of the machine.
The opened main cover is to be secured by the support rod. Place the
support rod for the main cover in a safe and stable position.
Whenever working on electric and electronic parts of the machine it is
compulsory to first disconnect the negative terminal/pole of the battery!
Only use appropriate and faultless tools and equipment for your
maintenance and service work.
Every twelve (12) months, resp. 200 Operation hours, it will be
neceessary to have professional inspection of the Ride-on-Sweeper by an
authorized and competent person (primarly by the manufacturer or an
authorized dealer or trained specialist).
The results of this inspection must be kept to record in writing and to be
saved at least until the next inspection takes place.
Safety instructions
