10
Cleanfix —KS 1100—simply clean
Sweeping operation
Safety instructions
Do not switch on the vacuum motor when sweeping wet areas/wastes This would lead to
a clogged filter and damage to the vacuum motor. In closed rooms make sure to have a
proper room aeration. Never sweep wastes dangerous to health.
Operation of the cyclindrical brush
•
Start the Ride-on-Sweeper
•
Release the lever to lower the
cylindrical brush to the floor.
•
Switch the Tip switch to ON to start
the cylindrical brush
On the switch a control light will shine.
Stopping Cylindrical brush operation:
•
Switch the Tipp switch for the cylindrical
brush to OFF.
•
Pull the lever for the cylindrical brush up-
wards and let it sideways fall in the latch
Operation of the side brushes
•
The side brushes are fixed to swivel
connections. When the side brushes
collide with an obstacle they swivel to
the side which prevents damage to
the Ride-on-Sweeper.
•
Start the Ride-on-Sweeper
•
Release both levers which hold both
side brushes off the floor. The levers
are on the left and right side of the
steering pillar
•
Move the lever downwards
•
Switch the Tipp switch for side brus-
hes to ON position.
On the switch a control light will shine.
The side brushes begin to rotate.
Ending the side brush operation:
•
Switch off the Tipp switch for the
side brushes
•
Pull both lever of the side brushes
upwards and let it fall in each latch.
Operator panel
(without overhead disposal)
Switch for side brushes
Switch for cylindrical brush
Switch for vacuum motor (suction)
Emergency-Off—Main Switch
Switch for filter cleaning (vibration)
ON– and OFF Key switch
Battery charge status-indication
2 levers to lift and sink the side brushes
1 lever to lower the cylindrical brush
23
Cleanfix —KS 1100—simply clean
Maintenance Table
Daily Maintenance
•
Charge the battery
•
Check the machine for visible damage or functional errors
•
Check the state of the lamella-filter and clean it
•
Empty the waste box (hopper)
Additionally every 50 Operation hours
•
Clean and grease the battery terminals/poles
•
Check the condition of the Gel-wheels
•
Check the Cylindrical brush and see if worn out or if clogged by waste parts. If
necessary exchange the Cylindrical brush
•
Check the working height and cleaning range of the brushes. If necessary adjust.
•
Check the Side brushes and see if worn out or if clogged. If necessary replace or
readjust.
•
Check the cylindrical brush tunnel for stuck waste parts or clogged up dirt, which
narrow the brush tunnel and constraint the free movement of the cylindrical brush.
Additionally every 100 Operation hours
•
Check the cable insulation. If necessary replace the cable.
•
Check that the cable connection is properly fixed.
•
Grease the steering chain
•
Grease the drive chain of the Cylindrical brush
•
Check the brake tension, if necessary replace.
•
Check the vacuum suction for foreign particles / dirt and clean.
•
Test drive to check the functionability of all operational elements and controls
(switches, levers, pedals, steering, brushes etc.)
•
Check the Cylindrical brush if functions are out of tolerance (expansion/strain)
•
Check the state of wear and tear of all bearings
Additionally every 200 Operation hours
•
Check the functionability of the electric motor
•
Check the wear and tear of the carbon brushes and if necessary, replace.
•
Check the steering and it‘s play/clearance. If necessary retension the chain.
•
Check all electronic parts to see if dusty or dirty and vacuum clean.
