CLEAN BURN CB-200-CTB, Operator'S Manual

Page: 29 / 148

Coil Tube Boiler Operator's Manual: Models CB-200-CTB, CB-350-CTB, and CB-500-CTB
3-5
Dual-Stacked Boiler Assembly
Assembling the Dual-Stacked Boiler
WARNING: Use extreme caution when moving and lifting one of the CTB's (with a forklift)
into place on the support stand. One CTB can weigh up to 2000 pounds (approximate). Clean Burn
recommends placing safety blocking underneath the unit until it is properly installed and secured on the support
stand.
Failure to follow these basic safety guidelines may result in serious personal injury and/or
damage to the unit.
ATTENTION: Dual-stacked units may be installed in several combinations: two CB-200-CTB boilers, two
CB-350-CTB boilers, two CB-500-CTB boilers, or any combination of two models with the larger unit on the
bottom. For optimal system functioning and to prevent system damage,
each boiler must be installed/piped
individually as shown in Figure 3C.
1. Refer to Figures 3C and 3D. Move the support stand into the approximate position where the dual-
stacked boiler is to be installed, and place blocks (approximately 10 inches high) inside the stand to
provide safety support for the boiler.
NOTE: If the support stand has not
been assembled, refer to Figure 3B.
NOTE: Only use 7 1/2" legs when
stacking the boilers. Taller legs may be
unstable.
2. Use a forklift to carefully lift one CTB
into position over top of the support
stand.
WARNING: Secure the boiler to the
forklift prior to lifting to prevent
possible equipment damage or
personal injury.
3. Lower the boiler down onto the safety
blocks positioned inside the support
stand.
4. Insert bolts (provided) into the
keyhole slots in the boiler, and then
lift the stand in position against the
bottom of the boiler.
5. Tighten the bolts to firmly attach the
stand to the bottom of the boiler.
6. Carefully lift the assembled boiler
(with stand) off the safety blocks
and move the unit into place for the
rest of assembly.
NOTE: This boiler will be referred
to as the "bottom" boiler for the
remainder of this procedure.
(Procedure continued on page 3-6)
Figure 3C - Dual-Stacked Boilers (Completely Assembled)
I88688−C