CLEAN BURN CB-200-CTB, Operator'S Manual

Page: 28 / 148

Coil Tube Boiler Operator's Manual: Models CB-200-CTB, CB-350-CTB, and CB-500-CTB
3-4
WARNING: Use extreme caution when moving and lifting the CTB (with a forklift) into
place on the support stand. One CTB can weigh up to 2000 pounds (approximate). Clean Burn
recommends placing safety blocking underneath the unit until it is properly installed and secured on the support
stand.
Failure to follow these basic safety guidelines may result in serious personal injury and/or
damage to the unit.
1. Refer to Figure 3A to become familiar with the components required for CTB assembly.
2. Assemble the CTB support stand as shown in Figure 3B, using the hardware provided.
3. Move the support stand into the approximate position where the CTB is to be installed,
and place blocks (approximately 10 inches high) inside the stand to provide safety support for the
boiler.
4. Use a forklift to carefully lift the CTB into position over top of the support stand.
WARNING: Secure the boiler to the forklift prior to lifting to prevent possible equipment
damage or personal injury.
5. Lower the boiler down onto the safety blocks positioned inside the support stand.
6. Insert bolts (provided) into the keyhole slots in the boiler, and then lift the stand in position
against the bottom of the boiler.
7. Tighten the bolts to firmly attach the stand to the bottom of the boiler.
8. Carefully lift the assembled boiler (with stand) off the safety blocks and move the unit into place.
9. Proceed with the remainder of boiler assembly procedures marked for ALL CTB Models.
Installing the CTB on the Support Stand
Single Boiler Assembly
Figure 3B - Assembling the Support Stand
I88816-A
NOTE: When assembling the support stand, ensure that
the channel brackets are aligned as shown; fasten the
shorter brackets at the
innermost set of holes.