CLEAN BURN CB-1400, Operator'S Manual

Page: 35 / 108

Operator's Manual: Model CB-1400
4-7
Oil Tank Installation Specifications
Ensure that your tank installation adheres to the following
safety guidelines as stated here and in
Section 1 of this
manual.
The tank safety label (shown at right) also summarizes these
important specifications for tank installation and usage. If
you do not have a copy of this label, please contact your
Clean Burn dealer for a copy, which is to be affixed directly
to your used oil supply tank.
• The tank installation must meet all
national and local codes.
Consult your
local municipal authorities for more
information as necessary.
• The tank must be listed to UL 80 or
UL 142.
• Use a minimum 250-gallon tank.
DO NOT use a 55-gallon drum as a
substitute for an appropriate tank. The
tank must be large enough to allow water,
sludge, etc. to settle out of the used oil.
• The tank must have a manual shut-off
type valve on the side of the tank to allow
the water, sludge, etc. to be drained from
the bottom of the tank.
• All unused openings in the tank must be
plugged
or capped off.
• For optimal system functioning, Clean Burn
recommends
inside tank installations as
shown in Figures 4A, 4F, and 4J.
• The tank must be vented to the outside of
the building using iron or steel pipe and
fittings with an approved vent cap.
• Carefully review the oil tank and pump
installation details as shown in Figures 4A, 4F,
and 4J. Pertinent information is also supplied
with the metering pump and oil line installation
procedures (following in Section 4).
• Ensure that the oil supply tank is properly
maintained ; refer to Section 9 in this manual
for related procedures.
ATTENTION: For outside tank installations and/or tanks larger than 500 gallon , contact
the Clean Burn Service Department for installation recommendations and specifications.