Claydon HYBRID M3F, Operator'S Manual

Page: 40 / 60

H
IN FIELD OPERATION
40 OPERATORS MANUAL - HYBRID - M3F & M4RF
SETTING THE SEED SIZE SOWING RATE
1. Slider position decal location
Red lever (on shaft) out ( 2 ) maximum
opening 25
Red lever (on shaft) in ( 3 ) (max opening
105)
To select small Seed or Large seed settings:
With the metering unit empty wind in the slider to the fully closed position. Carefully rotate the red lever to
the desired position i.e.
out
for small seeds and
in
for large seeds as shown below. Then carefully wind the
slider back out to the desired rate required using the chart located on the side of the drill chassis as a guide.
0 10 20 30 40 50 60 70
Fine Seed
Normal Seed
80 90 100 110
Small seed setting Large seed setting
Set the seed rate required on the ISOCAN unit in the tractor. Now set the metering unit to the corresponding
setting using the table located on the side of the machine. Adjust the metering unit to the correct position
using the decal as a guide.
2. 3.
!
DO NOT REDUCE THE METERING SETTING WITH THE METERING
UNIT FULL THIS WILL RESULT IN DAMAGE TO THE METERING UNIT.
!