Front Hopper
[12]
*If a pin number is requested then enter: 1234
9.3 Second Fan
As there are now two fans associated with the drill and front hopper, the second fan is
required to be activated on the control box. This is achieved by completing the following
process:
*If a pin number is requested then enter: 1234
If the Front Hopper is not going to be used in conjunction with the drill at any point, then Fan
2 PPR will need to be set to Zero (Fertiliser fan turned off). This is achieved by carrying out the
above process again.
Factory setup*
Metering unit
Select the
Fertiliser
option
and press enter.
The settings displayed
above should be entered
into the box.
Press the “
Main”
button to
get back to the screen
shown
above.
Menu button
Menu button
Factory setup*
Tramline module
Fan 1 PPR =
2ppr
Fan 2 PPR =
2ppr
(Press enter once altered)
Press the “
Main”
button to get
back to the screen shown
above. Fan 1 should be visible.
If the “
Main”
button is
pressed, Fan 2 should
now be displayed.
