Chapter 4: cOS Core Configuration
• Management Workstation Connection, page 26
• Web Interface and Wizard Setup, page 29
• Manual Web Interface Setup, page 37
• CLI Setup, page 53
• License Installation Methods, page 61
• Setup Troubleshooting , page 63
• Going Further with cOS Core, page 65
4.1. Management Workstation Connection
cOS Core Starts After Power Up
It is assumed that the W30 unit is now unpacked, positioned correctly and powered is applied. If
not, the earlier chapters in this manual should be referred to before continuing.
Clavister's cOS Core network security operating system is preloaded on the W30 and will
automatically boot up after power is applied. After boot-up is complete, an external
management computer workstation can be used to configure cOS Core.
The Default Management Interface
After first time startup, cOS Core automatically makes management access available on a single
predefined Ethernet interface and assigns the private IPv4 address 192.168.1.1 to it.
For the W30, the default management interface is the G1 interface.
cOS Core Setup Methods
Initial cOS Core software configuration can be done in one of the following ways:
•
Through a web browser.
26
Summary of Contents for Wolf W30
