Clatronic NM 3466, Instruction Manual

Page: 42 / 47

42
CAUTION:
• When turning the stitch selector (1), the needle has to be
in upper position.
• While sewing do neither push nor pull the fabric. This can
cause the needle to break.
• This sewing machine is designed only for home use.
• Position the machine safely on a flat work space.
• In no case use another power supply than the one
delivered.
• When leaving the machine, switch the machine off and pull
the power supply plug out of the outlet.
Parts description / Scope of delivery
Overview of control elements on page 3:
Figure A (front side of the machine)
1 Stitch selector
2 Bobbin winder shaft
3 Bobbin winder edge guide
4 Hand wheel
5 Stitch selector symbols
6 Electrical connection
7 Button for reverse sewing
8 Lever for loosening the presser foot shoe
9 Table top with accessory compartment
10 Presser foot
11 Presser foot fastening bolt
12 Needle fastening bolt
13 Thread cutter
14 Upper thread tension control
15 Button for loosening the thread tension
16 Thread lever
17 Needle thread feed hole
18 Thread guide for spooling
Figure B (rear side of the machine)
19 Presser foot lever
20 Thread reel holder
Figures on page 4:
Figure C (accessories)
21 Foot controller
22 Power supply
23 Needles (2x)
24 Threading guide
25 Twin needle
26 Buttonhole foot
27 Needle plate elevation for bar tack and embroidery function
28 Screw driver
29 Thread reel holder
30 Zipper foot
31 Presser foot shoe
32 Seam cutter
33 Bobbin thread reels
Without figure:
Cleaning brush
100 piece sewing set
Unpacking the machine
1. Take the machine out of the packaging.
2. Remove all packaging material such as foils, fillers, cable
brackets and card box packaging.
3. Check the delivery for completeness.
Application instructions
Folding table top (Fig. D and E)
Empty bobbin thread reels and other accessories are stored in
the table top.
1. Pull the folding table top out horizontally (Fig. D).
2. Shift the accessory compartment lid to the right as indicated
by arrow markings and open it (Fig. E).
Thread reel holder (29)
Take the thread reel holder out of the table top and insert it into
the guide at the rear side of the machine (20).
Electrical connection (Fig. F)
1. Connect the power supply plug with the machine (a).
2. Connect the power supply with a 230 V~, 50 Hz outlet
installed according to regulations (b).
3. Connect the foot controller with the machine (c).
4. Set the On/Off switch to “ I ”.
5. The machine speed can be controlled by pressing the foot
controller.
Switching On / Off
• Switch position “ I ”: Machine and LED sewing lamp on.
• Switch position “ ”: off
LED sewing lamp
The LED sewing lamp is maintenance free and does not need
any replacement.