First Use of the Machine
•
Before making coffee in the machine for the first time rinse two to three times
with cold water in order to clean the machine.
•
Clean the filter pad and the glass pot by rinsing.
Electrical Connection
•
Make sure that the machine is switched off (operating switch on "OFF").
•
Before inserting the mains lead into the socket, check whether the voltage you
intend to use complies with that of the machine.
For details see the machine label.
•
Only connect the machine to a properly installed safety socket, 230 V/50 Hz.
Operation
1. Pull the lid of the water tank forwards. Fill the machine to the number of cups
required with cold water.
2. Swing the filter out to the right. Insert a filter (size 1 x 2) into the filter funnel and
fill it with coffee powder. Then close the filter holder until it locks in place.
3. Place the pot on the hot plate and close the lid of the water tank.
4. Turn the switch to position “ON/1”. The coffee will begin to percolate. After perco-
lation you may remove the pot.
5. If you would like to keep the remaining coffee warm, the switch must remain in
position “ON/1”. The hotplate will keep the coffee warm until the switch is moved
to the “OFF/0” position. The machine is then switched off.
Descaling
Descaling is necessary when the time needed to prepare coffee becomes consider-
ably longer.
Only commercially available descaling products based on citric acid should be
used.
Cleaning
Before cleaning the machine you should always remove the mains lead and wait
until the machine has cooled down. The machine should only be cleaned with a
slightly damp cloth. Do not use any strong detergents or solvents for cleaning. The
coffee pot and the filter pad should be cleaned by rinsing in cold water.
This appliance conforms with the CE directives for radio interference suppression
and low-voltage safety and has been built to meet current safety requirements.
Subject to technical changes without prior notice!
24
GB
34947-05-KA 2508 15.12.2003 14:16 Uhr Seite 24
