Clatronic DBS 3162 R, Instruction Manual

Page: 32 / 54

E
N
G
L
IS
H
ENGLISH
32
Steam Quantity Control
high steam volume
small steam volume
With the steam quantity control
you can set the desired steam
quantity.
Water Tank
The water tank has a recessed grip on the bottom so that it can
be removed. This makes it easier to fi ll up.
The volume of the water tank is 900 ml.
Water
Only tap water should be used. Do not use any decalcifi ers!
These will destroy the device!
The following is also unsuitable: Do not fi ll battery water,
water from the clothes dryer and water containing additives
(such as starch, perfume, softener or other chemicals) into the
water reservoir.
This could damage the iron due to residues forming in the steam
chamber. These residues may cause impurities to the fabric
when dropping out of the holes in the soleplate.
Lock/Lime Filter
The lock of the water tank is also the lime fi lter cartridge. Take
out the lime fi lter cartridge to fi ll with water.
Lime Filter Regeneration
Depending on how often you use the station, lime has to
be removed from the fi lter medium every one to two weeks
(regeneration).
• To do so, unscrew the lid (d) from the cartridge (c).
• Release the cap (a).
• The bags (b) with the fi lter medium are located in the lime
fi lter cartridge.
• Prepare a salt solution of 500 ml of water and 50 g of
special salt for dishwashers.
• Immerse the bags with the fi lter medium in the solution for 2
hours.
• Reassemble the parts and your station is ready for operation
again.
Before Initial Use
Clean the ironing base with a slightly damp cloth.
CAUTION: INITIAL USE:
Before initial use the station has to be operated for 1 minute
with water.
Please proceed as follows:
• Remove the water tank and the lime fi lter cartridge.
• Fill in fresh tap water up to the maximum mark. Do not
overfi ll!
• Close the water tank and place it back in the base.
• Connect the base station to a 230 V / 50 Hz socket with
earthing contact.
• Turn the temperature control to MAX. The control lamp on
the iron lights up.
• Wait until the soleplate has heated up. Once the temperatu-
re has been reached the control lamp goes off.
• Please wait until the control lamp on the iron has switched
itself off three times again.
• Now press the steam jet button for at least 1 minute or use
the lock to fi x the steam jet button in place.
NOTE:
This time is needed to transport the water from the tank
to the iron.
• When the fi rst steam is expelled by the iron you can stop
the procedure. Then press the steam jet button another 2-3
times without touching the clothes that are to be ironed.
• After you have ironed an old but clean cloth a few times,
your station is ready for use.
Operation
Ironing without steam
NOTE:
• Sort out the garments according to their ironing temperatu-
res.
• Always set the temperature control to „ MIN “ before
connecting the appliance to a power point, or before
disconnecting it.
• Only connect the machine to a properly installed safety
socket, 230 V/50 Hz.
• Start with the lower temperatures. It is set with the thermos-
tat (1).
• Place the iron on its stand.
• The control lamp on the iron shows that it is heating up. As
soon as this goes off, the operating temperature has been
reached. As soon as the control lamp goes off the operating
temperature has been reached. Now you can start ironing.
Always turn the temperature control to „
0 “ after use and
remove the mains plug (the control lamp in the handle goes
off).
Steam Ironing
WARNING:
The iron expels a large quantity of hot steam. Danger of
burns.
CAUTION:
When using the steam iron please ensure that the water tank
is always fi lled to the required level. Operation without water
will damage the pump.
05_DBS 3162 R 32 14.08.2007, 9:45:04 Uhr
Паровая система CLATRONIC DBS 3162 R
Купить в интернет-магазине http://clatronic-shop.com.ua