10
PARTS NEEDED
TOOLS NEEDED
CLASSICACCESSORIES.COM
STEP 4
INSTALL FRAME MOUNTING POSTS (FIG. 1-2)
INSTALL ASSEMBLED CAB ON LOWER MOUNTING POSTS (FIG. 3-4)
Note: Fabric shell will be tight when properly assembled.
1b
Assemble mounting post upper
clamp [K] to the top plate [L]
on the outer edge of the frame
[A]. Secure with four washers
[S] and two hex bolts [R].
Hand tighten. Later adjustment
may be necessary to line up with
the lower mounting posts [M].
Lift the assembled cab up to the snow thrower and align the
mounting posts up to the frame posts. Then insert the mounting
post, upper clamp [K] into the mounting post, lower [M].
1/2 in. Box
Wrench
OR
OR
1/2 in. Socket
Wrench
Adjustable
Wrench
Note: it may be necessary to adjust the frame posts or mounting posts
in order to get the cab into position. Adjust cab position and mounting
as needed to not interfere with your snow thrower parts or controls.
3
4
Snow Cab
shell pulled aside
for visibility
Snow Cab
shell pulled aside
for visibility
SPRING CLIP
INSTALLED AT FACTORY
KNOB WITH M8 STUD
4MM ALLEN WRENCH
M8 X 30 HEX BOLT
M8 WASHER
SPRING CLIP
INSTALLED AT FACTORY
KNOB WITH M8 STUD
4MM ALLEN WRENCH
M8 X 30 HEX BOLT
M8 WASHER
Repeat with the other
mounting post set on the
opposite side of the frame.
+
2
K
Q
S
L
K
S
R
1
L
Snow Cab
shell pulled aside
for visibility
A
L
K
SPRING CLIP
INSTALLED AT FACTORY
KNOB WITH M8 STUD
4MM ALLEN WRENCH
M8 X 30 HEX BOLT
M8 WASHER
SPRING CLIP
INSTALLED AT FACTORY
KNOB WITH M8 STUD
4MM ALLEN WRENCH
M8 X 30 HEX BOLT
M8 WASHER
SPRING CLIP
INSTALLED AT FACTORY
KNOB WITH M8 STUD
4MM ALLEN WRENCH
M8 X 30 HEX BOLT
M8 WASHER
SPRING CLIP
INSTALLED AT FACTORY
KNOB WITH M8 STUD
4MM ALLEN WRENCH
M8 X 30 HEX BOLT
M8 WASHER
Q
R
S
