7
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
32. Keep blades sharp and clean for better and safer performance. Inspect
power cables periodically and if damaged have them repaired.
33. Repairs should only be carried out by qualified persons using original spare
parts, otherwise this may result in considerable danger to the user.
34. Keep handles dry, clean and free from oil and grease.
35. Unplug the saw - switch off and wait for the blade to come to a complete
standstill before leaving it unattended.
ADDITIONAL SAFETY RULES FOR TABLE SAWS
1. The thickness of the saw blade must be greater than the thickness of the
riving knife.
2.
DO NOT
stand on the table saw.
3. During transportation make sure that the upper part of the saw blade is
covered by the guard.
4.
DO NOT
use the guard for handling or transportation.
5. Check that the workpiece is properly supported.
ALWAYS
provide
additional support for long workpieces.
6.
DO NOT
exert side pressure on the saw blade.
7. Make sure that the blade rotates in the correct direction and that the teeth
are pointing to the front of the saw.
8.
DO NOT
apply lubricants to the blade when it is running.
9.
NEVER
reach around or over the saw blade. NEVER reach for a workpiece
until the saw blade has completely stopped.
10. Make sure that the blade and retaining discs are clean. Tighten the
retaining screw securely.
11. Keep the saw blade sharp.
12. Make sure that the riving knife is adjusted to the correct distance from the
blade.
13.
NEVER
operate the saw without the guard in place.
14.
DO NOT
use abrasive discs or diamond cutting wheels.
15. Rebating, slotting or grooving is not allowed.
16.
DO NOT
use a moulding head cutter with this saw.
17. Remove the rip fence when crosscutting. Never use the rip fence as a cut-
off gauge when crosscutting.
18. Knock out any loose knots from the workpiece before you begin to cut.
Summary of Contents for WOODWORKER 6460015
Page 32: ......
