21
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
ADJUSTMENTS
SETTING THE BLADE HEIGHT
1. Set the blade height as required
by using the adjustment handle
under the work table.
• The height scale shows the
height above the table top.
SETTING THE BLADE ANGLE
1. Release the bevel locking knobs
on either end of the machine.
2. Tilt the saw blade and motor
assembly until the saw blade is at the desired angle as displayed on the
scale below the table.
3. Tighten the bevel locking knobs to lock the blade at the required angle
displayed on the scale.
ADJUSTING THE PARALLEL FENCE
1. Slide the fence along the table
and use the scale on the table to
set the parallel fence to the
required distance from the blade.
2. Lock the fence in the required
position by tightening the locking
handles at either end.
ADJUSTING THE MITRE GAUGE
1. Loosen the locking cam lever and
swivel the mitre guide to the
angle required.
• The face closest to you will
align with the angle shown in
degrees on the scale.
2. Re-lock the cam lever to secure.
If required you can remove the fence
from the mitre assembly using the 2 x
wingnuts, or slide it in either direction
to suit the task before re-tightening. You can also re-install the fence either
laying down or upright. See page 19.
Summary of Contents for WOODWORKER 6460015
Page 32: ......
