Clarke Vantage 13, Operator'S Manual

Page: 20 / 78

ENGLISH
18 Operator’s Manual - Vantage 13
TROUBLESHOOTING
Trouble Possible Cause Remedy
The motors do not turn on.
The power supply cable is faulty or
disconnected from the electrical mains.
Replace the cable or connect it.
Dirty water vacuuming is insuf fi cient or there is
no vacuuming.
The vacuum grid is clogged. Clean.
The vacuum hose is disconnected from the
deck or it is damaged.
Connect or replace.
The squeegees are dirty or the squeegee
blades are worn or damaged.
Clean or replace the squeegees.
The gasket of the transparent cover is
damaged. Check and/or clean the seating surface or
replace the gasket.
The vacuum system motor is faulty. Replace (*).
The solution fl ow is insuf fi cient. The solution fi lter is dirty. Clean or replace.
The brushes do not turn.
The driving belt is loosened or broken. Adjust or replace (*).
The brush motor is damaged. Replace (*).
The squeegee leaves marks on the fl oor.
There are debris under the squeegee
blades.
Remove the debris.
The squeegee blades are worn, chipped or
torn.
Replace the blades.
The fl oor is wet with dirty water.
The recovery tank is full and the excess of
dirty water is ejected.
Empty the tank.
This maintenance procedure must be performed by Clarke authorized Service Center. (*)
For further information refer to the Service Manual, available at any Clarke Service Center.
SCRAPPING
Have the machine scrapped by a quali fi ed scrapper.
Before scrapping the machine, remove and separate the following materials, which must be disposed of properly according to the
Law in force (local guidelines):
Brooms –
Electrical and electronic components (*) –
Refer to the nearest Clarke Center especially when scrapping electrical and electronic components. (*)