Clarke Vantage 13, Operator'S Manual, Page: 15 / 78

ENGLISH
Operator’s Manual - Vantage 13 13
MACHINE TRANSPORT/PARKING
To transport/park the machine, proceed as follows.
Turn off the machine by pressing the switch (6). 1.
Disconnect the power supply cable (10) from the electrical mains and place it on the holder (7). 2.
Push the machine with the handlebar (2) and keep the brush/squeegee-holder deck slightly lifted. 3.
Lift the machine and turn the parking lever (24, if equipped) to position (24b). 4.
TANK EMPTYING
WARNING!
To avoid spilling the water (for example during an abrupt machine maneuver), drain the recovery tank (16) at the
end of every cleaning cycle.
Use the transparent cover with vacuum grid (15) to check if the recovery tank (16) is full.
CAUTION!
If the recovery tank (16) is not emptied when full, the vacuum system ejects the excess of liquid through the air
outlets, thus dampening the
fl oor.
When the recovery tank (16) is full, empty it as shown below.
Recovery tank and solution tank emptying
Turn off the machine by pressing the switch (6). 1.
Disconnect the power supply cable (10) from the electrical mains and place it on the holder (7). 2.
Drive the machine to the appointed disposal area. 3.
Lift the brush/squeegee-holder deck and turn the parking lever to position (24b). 4.
Carefully remove the quick coupling (28) from the solution tank. 5.
Move the transparent cover (15) aside and lift the tanks with the handle (26). 6.
Open the recovery tank drain plug (19) and empty the tank. 7.
If necessary empty the solution tank (14) by opening the plug (18). 8.
Then, rinse the tanks and the solution hose fi lter (25) with clean water.