3
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
• Never tamper with the press. The safety valve is calibrated and sealed at the
factory; do not attempt to change the setting.
• Use only the recommended hydraulic oil.
• Components of this press are specially designed to withstand the rated
capacity. Do not substitute bolts, pins, or any other components.
• Always apply the load under the centre of the ram. Offset loads can
damage the ram or ram mount and may cause the work piece to eject.
• Before operating, check for signs of cracked welds, bent bed pins, loose or
missing bolts, or any other structural damage. Do not operate if any of these
conditions exist. Have repairs made only by authorised service centre.
• Remove load from press bed before attempting to adjust bed height.
• Press only on a work piece supported by the press bed.
• When using accessories such as arbor plates, be certain they are centered
below the ram and are in full contact with the bed.
• Parts being pressed may splinter, shatter, or be ejected from the press. Due to
varied applications, it is your responsibility to always use adequate guards,
wear eye protection and protective clothing when operating this press.
• Keep hands and fingers away from parts that may pinch and shift.
• Failure to heed these warnings may result in damage to the equipment, or
failure resulting in property damage, personal, or even fatal injury.
• DO NOT use extension tubes on the pump handle. Excessive effort can cause
damage and/or accidents.
UNPACKING
Ensure the press and its components suffered no damage during transit and
that all components are present. Should any loss or damage become
apparent, please contact your CLARKE dealer immediately.
TOOLS REQUIRED
• Spanners to suit M6, M8 and M10 nuts/bolts, or an adjustable wrench.
• PTFE tape
ACCESSORIES
A mandrel set (including storage bracket and pressure plate) is not supplied
with the press but is available from your dealer as Clarke part no 7615060.
Summary of Contents for STRONG-ARM CSA10BB
Page 16: ......
