8
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
USING YOUR BUFFER/POLISHER
1. Plug the buffer/polisher into the mains power supply.
2. Switch the buffer/polisher on
3. Slowly bring the workpiece into
contact with the polishing mop.
• See the image on the right to
determine the safest and best
position for contact with the
wheel.
• DO NOT contact the wheel
outside of the quadrant.
4. After use, unplug the buffer/polisher from the mains power supply, and
clean the machine ready for next use.
MAINTENANCE
1. Regularly inspect the buffing/polishing pad. Replace when worn.
2. Keep the buffer/polisher clean and dry. DO NOT use abrasives.
• The motor and bearing are sealed units and require no maintenance.
CLEANING & STORAGE
1. Clean the exterior the machine if required using a mild detergent or mild
solvent.
2. Never immerse the buffer/polisher in water.
3. Keep any cooling vents in the buffer/polisher free of debris.
WARNING: BEFORE COMMENCING WORK, ENSURE YOU HAVE READ AND
UNDERSTOOD ALL OF THE SAFETY INSTRUCTIONS
WARNING: MAKE SURE THAT THE BUFFER/POLISHER IS UNPLUGGED FROM
THE MAINS POWER SUPPLY BEFORE PERFORMING ANY MAINTENANCE.
Summary of Contents for METALWORKER 6500491
Page 12: ......
