10
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
OPERATION
GETTING STARTED
1. Ensure that the water supply is correctly connected and turned on.
2. Plug the power cable into the
mains supply.
3. Release the trigger lock.
• The pressure washer is now
ready for use.
4. Press the start switch (‘I’).
5. Pull the trigger.
NOTE:
When the trigger is pulled the
pressure of water will cause
the lance/gun assembly to
kick back suddenly.
6. When using the power washer for
the first time, let it run for a few
moments so that any air bubbles
or other impurities are discharged.
7. Release the trigger to stop the water flow.
• This pressure washer is fitted with an auto stop system to protect the
motor during use.
• When the trigger is released, the motor will stop. When the trigger is
squeezed the motor will start up again.
WARNING: FAILURE TO TURN ON THE WATER FULLY COULD CAUSE
DAMAGE TO THE POWER WASHER INTERNAL COMPONENTS.
WARNING: DO NOT USE THE POWER WASHER IF THE SUPPLY CABLE OR
IMPORTANT PARTS OF THE MACHINE ARE DAMAGED, E.G. SAFETY
DEVICES, HIGH PRESSURE HOSES, TRIGGER
WARNING: WE RECOMMEND THAT THIS MACHINE IS CONNECTED TO THE
MAINS SUPPLY VIA A RESIDUAL CURRENT DEVICE (RCD)
Summary of Contents for JET 8000
Page 24: ......
