10
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
CONNECTING THE WATER SUPPLY
The pressure washer must never be connected to the drinking water supply
without using a system separator (also known as a backflow preventer)
available from most hardware stores.
Always follow the regulations of your local water supplier.
1. Connect the water supply hose to
the inlet fitting.
2. Connect the inlet fitting to the
Water inlet as shown.
• It is recommended to use a
reinforced hose having an
inner diameter of at least 10
mm.
• The water supply must be able
to deliver at least 15 l/min. and
have a max inlet temperature of 55 °C.
PARKING BRAKE
Before you operate you pressure washer you should make sure that the
parking brake is engaged.
To do this screw the brake shown in
the picture against the wheel to
engage the parking brake.
Screw the brake in the opposite
direction to release the parking
brake, and allow you to move the
pressure washer.
CAUTION: WATER THAT HAS FLOWED THROUGH A SYSTEM SEPARATOR IS
CONSIDERED NON-DRINKABLE.
HLS160 3 Phase hot wash.fm Page 10 Wednesday, September 28, 2011 12:28 PM
Summary of Contents for HLS160
Page 24: ......
