12
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
COLD WASH OPERATION
1. Turn the water supply tap on, making sure that it is fully open.
2. Set the mode selector (A) to
position 2 (pump setting)
3. Set the Temperature selector (B)
to “0” for cold washing.
• The pressure washer is now
ready for use.
4. Release the trigger lock.
5. Ensuring that you have a firm
footing and that you are also
holding the gun assembly and
spray lance firmly, pull the trigger
on the gun to start water flow.
• The lance and gun will kick
back when the trigger is first
pulled.
USING DETERGENT
The detergent is applied by twisting
the cap on the lance as shown and
then pulling the trigger on the gun.
WARNING: FAILURE TO TURN ON THE WATER FULLY COULD CAUSE
DAMAGE TO THE PRESSURE WASHER.
CAUTION: IF YOUR EYES COME
INTO CONTACT WITH ANY
CLEANING FLUIDS, RINSE THEM
IMMEDIATELY WITH PLENTY OF
FRESH CLEAN WATER AND SEEK
MEDICAL ADVICE IF REQUIRED.
HLS160 3 Phase hot wash.fm Page 12 Wednesday, September 28, 2011 12:28 PM
Summary of Contents for HLS160
Page 24: ......
