11
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
OPERATION
1. The pressure washer should always be located on a firm level surface
where it is not exposed to extreme weather conditions such as strong wind,
freezing or rain.
2. It is recommended that where possible a partition be erected between the
wash area and the pressure washer to prevent accidental spraying of the
pressure washer. Moisture entering the pressure washer may cause serious
damage.
3. Do not operate the pressure washer indoors, or in enclosed areas without
adequate ventilation, or in areas where flammable vapours (petrol,
solvents etc.) may be present.
4. If the pressure washer is to be used in an enclosed area the burner exhaust
MUST BE vented to the outside atmosphere. The use of a draft regulator is
recommended. All venting must be in accordance with applicable laws
and local ordinances for such installations.
CONTROL PANEL
A
Operating Mode Selector
D
This is lit when the burner is on.
B
Temperature selector (from
0
°C
to 150 °C.)
E
This is lit when there is a lack of
fuel in the tank.
C
This is lit when connected to
an electrical power supply.
F
This flashes when the flame
turns off inside the boiler.
HLS160 3 Phase hot wash.fm Page 11 Wednesday, September 28, 2011 12:28 PM
Summary of Contents for HLS160
Page 24: ......
