13
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
• For standard discs make sure that the raised centre section of the
outer retaining disc is pointing towards the grinding disc
5. Screw on the outer retaining disc with the raised section facing inwards so
as to sit inside the aperture of the disc. Tighten securely with the pin
spanner.
• When using thin discs, the outer retaining disc can be reversed so
that the raised section is pointing away from the grinding disc.
6. With the spindle lock engaged, use the pin spanner to tighten the outer
retaining disc. Care should be taken also NOT to overtighten.
FITTING THE AUXILIARY HANDLE
1. Fit the auxiliary handle by
screwing it into the threaded hole
on either the top, left or right hand
side of the angle grinder.
Summary of Contents for CON1150
Page 21: ......
