7
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
• A typical air line layout is shown above. If an automatic in-line filter/
regulator is used, it will keep the tool in good condition, but should
be regularly checked and topped up with oil. SAE 10 oil should be
used, and the lubricator adjusted to approx 2 drops per minute.
BEFORE USE
NOTE:
Ensure the compressor is turned off.
1. If required, connect an in-line mini
oiler to the tool.
• A mini oiler helps to prolong the
life of the impact wrench.
Remove the oil fill screw from
the side of the mini oiler and fill
with Air-line Oil available from
your CLARKE dealer. Replace
the screw before using the
wrench.
2. If a mini-oiler is not being used, run
a few drops of oil through the tool
before use. It can be entered
through the inlet strainer or via the
hose at the nearest connection to
the air supply.
3. Connect a suitable hose as shown.
4. Connect the other end of the hose
to the compressor.
5. Your impact wrench is now ready
for use.
You can fit a whip hose with a quick fit coupling if required (available from
your Clarke dealer.)
WARNING: COMPRESSED AIR CAN BE DANGEROUS. ENSURE THAT YOU
ARE FAMILIAR WITH ALL PRECAUTIONS RELATING TO THE USE OF AIR
COMPRESSORS AND COMPRESSED AIR SUPPLY.
