6
BEFORE USE
If an automatic in-line filter-regulator-lubricator is not used, the following
procedure should be carried out before use and after every two to three
hours of use.
1. Drain water from air tank, air line
and compressor.
2. Remove the plug from the rear
of the cut off tool.
3. Check and clean the air inlet
gauze filter.
4. Pour 2-3 drops of Clarke air line
oil (approx. 3 cc), into the air
inlet. This should be carried out
regardless of whether or not an air line lubricator is used.
5. Connect tool to air supply, turn ON the air supply, and check for air leaks.
If any are apparent, rectify before proceeding.
ASSEMBLY
NOTE
:
Ensure the airline is turned off.
1. Screw in the adaptor supplied.
2. Connect a suitable air hose to
the cut -off tool using a ¼” hose
adapter, (A whip hose with
quick fit coupling is available
from your CLARKE dealer). Then
connect the other end to the
airline.
Your cut-off tool is now ready for use.
•
NEVER use cracked or chipped cutting discs.
•
NEVER use non-reinforced cutting discs.
•
NEVER use the cut off tool without disc guard in place.
•
NEVER use the side of the cutting disc for grinding.
•
ONLY use for cutting operations.
•
ALWAYS ensure the cutting disc has stopped before putting it down.
IMPORTANT
Gauze Filter
(located here)
