7
OPERATING INSTRUCTIONS
WARNING: ENSURE YOU READ, UNDERSTAND AND APPLY SAFETY
INSTRUCTIONS BEFORE USE.
1. Push safety lever (mounted on
the throttle lever) forward and
depress throttle lever.
•
Allow tool to run up to full
speed for a couple of
seconds before offering disc
to work piece.
2. Apply a steady, even pressure.
Do not force. Too much pressure
can cause disc to break and
may even cause injury.
NOTE: DO NOT allow tool to free run for an extended period of time as
this will shorten its life.
CHANGING THE CUTTING DISC
WARNING: ENSURE AIR IS TURNED OFF AND TOOL IS DISCONNECTED
FROM THE AIR SUPPLY BEFORE REPLACING DISC.
1. Ensure the disc being fitted has a speed rating greater than 18,000 RPM.
2. Install disc using spanner and
hex key supplied. Ensure that the
spacer is in place.
IMPORTANT: The use of parts other
than CLARKE replacement parts
may result in safety hazards,
decreased tool performance and
may invalidate your warranty.
Replacement cutting discs are available from your Clarke dealer.
Part number 3110731
