Scrub System
40
Service Manual – CA90 32T
Removal and Installation
Brush Motor
Removal
•
Completely drain the recovery tank.
•
Lift the recovery tank, and secure the tank support latch.
•
Remove the front cover of the machine by removing the (4) knobs.
•
With the machine key in the ON position, raise the brush deck to it’s full up position using the actuator
switch.
•
Turn the key to the OFF position, and disconnect the batteries.
•
Remove the 13mm bolt that holds the drive plate assembly onto the brush motor shaft.
•
Slide the drive plate assembly off the motor shaft. (NOTE: You may have to wiggle the drive plate back
and forth to remove it)
•
Set aside the drive plate, bolt, washer, and shaft key.
•
Remove the (4) bolts/lockwashers that attach the brush motor to the deck
•
Cut the wire ties that secure the connector bundle.
Drive Plate Bolt