11
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
1. With the help of an assistant, lift up
the head assembly and locate it
on top of the column, ensuring it
slides fully home.
2. Align the head assembly with the
machine base and tighten the
head locking set screws shown in
Fig 6 using the hex key supplied.
3. Take the feed handle assembly
and screw it firmly into the hub of
the feed shaft as shown in Fig.7.
Add the hub cover with its
retaining screw.
CHUCK GUARD ASSEMBLY
NOTE:
This task should be carried
out before the chuck is
installed.
1. Slide the chuck guard over the
quill shaft and nip up the pinch
bolt, temporarily, with the pinch
bolt facing the front as in fig 8.
• This will make fitting the chuck
easier. Ensure the quill shaft/
drive spindle is at the top of it’s
travel.
INSTALLING THE CHUCK
1. Open the jaws of the chuck as far
as possible using the chuck key
supplied. E
nsure the tapered hole
in the chuck is clean and fit the
chuck onto the tapered end of
the drive spindle with a firm
pressure
.
2. Tap the chuck firmly with a rubber
mallet until the tapered end of
the chuck engages with the drive
spindle
Summary of Contents for 6505592
Page 28: ......
