9
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
UNPACKING
The drill press is delivered with the components shown on page 8.
Check the parts against the list on page 8. Should there be any deficiencies or
damage, you should contact your CLARKE dealer immediately where the
product was originally purchased. Do not discard the packaging until the
machine is assembled. The packaging consists of cardboard and
appropriately marked materials which can be sent to a re-cycling facility.
To protect the machine parts from moisture, a protective coating of light
machine oil will have been applied to the outside surfaces. Remove any
excess with a paper towel.
Take care when lifting the head assembly, considering its weight.
Before use, the machine must be securely bolted to the workshop floor.
ASSEMBLY
COLUMN TO BASE
1. Bolt the lower column to the base
with the four bolts and washers.
2. Add the column tube to the lower
column & secure with set screws.
NOTE:
Ideally, the base with column
should be firmly bolted to
the workshop floor, prior to
the assembly of other
components.
TABLE TO COLUMN
1. Push the crank on to the worm
drive spigot protruding from the
gear housing. Tighten the crank
set screw onto the flat side of the
spigot using a hex key supplied.
Summary of Contents for 6505592
Page 28: ......
