13
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
SETTINGS AND ADJUSTMENTS
WORK TABLE
The work table may be raised,
lowered or swivelled around the
column, by slackening off the table
support locking handle and adjusting
the table position accordingly before
retightening the locking handle.
It may also be tilted by loosening the
bolt which secures the table to its
mounting, tilting the table to the
required position and retightening
the bolt shown in Fig 13.
A bevel scale is provided on the
table mounting, (measured in
degrees), to assist in setting the
required angle. However, for greater
accuracy the use of a protractor is
recommended.
For all normal operations, the table
should be set to 0°.
To check to ensure the drill is
perpendicular to the table, install a
large drill bit in the chuck, place a set square on the table, and bring it up to
the drill. Adjust the table if necessary, so that it is perfectly level.
Summary of Contents for 6505592
Page 28: ......
