9
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
ASSEMBLY
SECURING THE SANDER TO A WORKBENCH
If sander is to be used in a permanent location, it should be fastened securely
to a workbench via the four securing holes (one on each corner).
1. Mark out the position of the holes.
2. Secure using suitable bolts, washers, and nuts (not supplied).
An alternative method is to fasten the sander to a mounting board.
The board should be sufficient size to avoid tipping while in use. Any good
grade of 3/4" plywood or chipboard will be sufficient.
The mounting board can then be clamped to a workbench when required.
DUST EXTRACTION
1. Connect a suitable dust collector
to the dust extraction port.
• The dust exhaust port has an
internal diameter of 36 mm and
an outside diameter of 39 mm.
NOTE:
Even with a dust collection
system, it is necessary to
periodically clean sanding
dust from the recess in the
table. A build up of dust in the
table recess may prevent the belt or spindle from making a complete
oscillation.
WARNING: CONTACT WITH, OR INHALATION OF DUST FROM LEAD BASED
PAINTS CAN ENDANGER THE HEALTH OF THE OPERATOR AND
BYSTANDERS. ALWAYS WEAR A SUITABLE DUST MASK WHEN USING THE
SANDER.
Summary of Contents for 6500460
Page 24: ......
