12
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
SANDING BELT TRACKING
1. Plug in the power cable. Turn the
switch ON and immediately turn
the switch OFF again. Note if the
belt tends to slide off the drums.
• If it did not tend to slide off, it is
tracking properly.
• If the sanding belt runs down
(towards the table), turn the
tracking knob clockwise 1/4 turn.
• If the sanding belt runs up (away from the table), turn the tracking
knob counterclockwise 1/4 turn.
2. Turn the switch ON and immediately OFF again, noting belt movement.
Readjust the tracking knob if necessary.
BOBBIN SANDING SETUP
SELECTION OF SPACER RING INSERTS AND SPINDLE WASHERS
You must use the correct spacer ring and washers when fitting the bobbins
ASSEMBLING THE BOBBIN
Slide the sanding sleeve over the
drum as shown.
• If the sanding sleeve is difficult
to slide over the drum, apply
talcum powder to the outside
surface of the drum.
• The smallest sanding sleeve
slides directly onto the spindle
shaft and does not require a
drum.
Bobbin
Size
What Sanding Sleeve
should you use
What drum should
you use
What spacer ring should
you use (inside diameter)
What washer
should you use
½"
½"
None
½"
Small
¾"
¾"
¾"
¾"
Small
1"
1"
1"
1"
Medium
1½"
1½"
1½"
1½"
Medium
2"
2"
2"
2"
Large
Summary of Contents for 6500460
Page 24: ......
