15
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
ADJUSTING THE TABLE ANGLE
1. Loosen the table adjustment
knobs (one each side) and move
the table to the required angle.
• There are stops on the right
hand bracket at the following
angles 0, 15, 22.5, 30, and 45
degrees.
• Use a protractor or set square
to confirm the angle.
2. Retighten both table adjustment
knobs.
PARTS STORAGE
1. The storage slots on the front are
used to store bobbins/sanding
sleeves and washers.
2. Spindle nut wrench and spacer
rings and the are stored on the
sides.
3. The edge sander is stored at the
rear.
WARNING: BEFORE PERFORMING ANY ADJUSTMENT, MAKE SURE THE
SANDER IS SWITCHED OFF AND UNPLUGGED FROM THE POWER SUPPLY.
FAILURE TO HEED THIS WARNING COULD RESULT IN SERIOUS PERSONAL
INJURY.
Summary of Contents for 6500460
Page 24: ......
