6
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
4. Never use damaged or incorrect grindstones. The stone and retaining
fixtures were specially designed for your grinder, for optimum performance
and safety of operation. Inspect the condition of the grinding stone before
use and do not use if any damage is found.
5. Always use the tool rests to steady the workpiece, the torque of the
spinning grinding wheel may pull the workpiece from your hands.
6. ALWAYS check for damaged parts. Before further use any part that is
damaged should be carefully checked to determine if it would operate
properly and perform its intended function. Check for misalignment or
binding of moving parts, breakage of parts and any other condition that
may affect the tool's operation. A part that is damaged should be properly
repaired or replaced at an authorised service center. Following this rule will
reduce the risk of electric shock, fire or serious injury.
NOTE:
Bench grinders used in industrial environments may be subject to
the requirements of The Provision and Use of Work Equipment
regulations 1992 (particularly regarding the training requirement
of The Abrasive Wheels Regulations 1970), or other legislation. If in
doubt seek advice.
Please keep these instructions in a safe place for future reference.
SAFETY SYMBOLS
The meanings of the markings and symbols on the product are shown below
Read this manual
before use and keep
in a safe place for
future reference
Wear eye protection
when using this tool.
Gloves should be
worn when grinding.
Wear dust mask.
Summary of Contents for 6500112
Page 16: ......
