10
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
OPERATION
NOTE:
Check that there is approx a 1.5 mm clearance between the tool rest
and the surface of the grinding wheel. Adjust as necessary.
NOTE:
Check the gap between the spark deflectors and the surface of the
grinding wheel. These should also be a maximum of 2 mm. Adjust as
necessary.
NOTE:
Check that the eyeshields have been secured in the correct position
and that the grinding wheel lock nuts are tight.
1. Stand to the side of the bench grinder and switch it on using the on/off
switch.
• Let the wheels reach full speed before use.
• The wheel rotates in the same direction as the arrow stamped in the
side of the wheel guard.
2. Hold the work piece firmly against the tool rest. Hold very small pieces with
pliers or other suitable clamps.
3. Press the workpiece smoothly and evenly against the grinding wheel.
4. Always keep the workpiece moving across the face of the wheel. Grinding
against the same part of the wheel will cause uneven wear of the wheel
face.
• Grind only on the face of the grinding wheel and never the side of it.
NOTE:
Prolonged grinding will cause tools/workpieces to become hot. Take
care when handling hot items.
5. Switch the bench grinder off using the on/off switch when you have
finished.
DRESSING THE GRINDING WHEEL
The grinding wheel may need dressing occasionally. Only dress the wheel with
a proper dressing tool whilst wearing safety goggles or glasses. If in doubt seek
professional advice. Dressing tools are available from your CLARKE dealer.
Grinding wheel dresser model no ET125;- part no 1700225
CAUTION: KEEP ALL BYSTANDERS AT A SAFE DISTANCE AND NOT IN
DIRECT LINE WITH THE, FRONT OR BACK OF THE GRINDER.
CAUTION: ALWAYS WEAR SAFETY GLASSES.
Summary of Contents for 6500072
Page 16: ......
