4
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
POWER TOOL USE AND CARE
1.
DO NOT force the power tool. Use the correct power tool for your
application.
The correct power tool will do the job better and safer at the
rate which it was designed.
2.
DO NOT use the power tool if the switch does not turn it on and off.
Any
power tool that cannot be controlled with the switch is dangerous and
must be repaired.
3.
Store idle tools out of the reach of children and do not allow persons
unfamiliar with the power tool or these instructions to operate the power
tool.
Power tools are dangerous in the hands of untrained users.
4.
Maintain power tools. Check for misalignment or binding of moving parts,
breakage of parts and any other condition that may affect the power tools
operation. If damaged, have the power tool repaired before use.
Many
accidents are caused by poorly maintained power tools.
5.
Keep cutting tools sharp and clean.
Poorly maintained cutting tools with
sharp cutting edges are less likely to bind and are easier to control.
6.
Use the power tool and accessories in accordance with these instructions
and in the manner intended for the particular type of power tool, taking
into account the working conditions and the work to be performed.
Use of
the power tool for operations different from intended could result in a
hazardous situation.
HAMMER DRILL SAFETY INSTRUCTIONS
1. ONLY use the drill in the manner and for the functions described.
2.
Using the correct bit.
Use the appropriate drill bit for the material being
drilled. Different bits are available from your Clarke dealer.
3.
Use of the mains cable
. Keep the mains cable well away from the drill and
ensure an adequate electrical supply is close at hand so that the
operation is not restricted by the length of the cable.
4.
Working on the bench.
Allow sufficient clearance beneath the work to
ensure the drill bit does not come into contact with the floor, table etc.
5.
Switching off.
Never place the drill on a table or bench if it has not
completely stopped. The drill bit will continue to rotate for a short time after
the trigger has been released to stop the drill.
6.
Drilling into walls.
DO NOT drill into walls or cavities before checking for
hidden electrical wires or water pipes etc.
7.
Finishing drilling.
DO NOT touch the drill bit immediately after use, allow
time for it to cool.
8.
Use outdoor extension leads
. If working outdoors, ALWAYS use an
Summary of Contents for 6479504
Page 16: ......
