11
Parts & Service: 020 8988 7400 / E-mail: [email protected] or [email protected]
• ALWAYS start drilling at the slowest speed to prevent the drill from
slipping out of the pop mark or indent.
• Select the speed according to the drill bit being used whilst
maintaining a MODERATE pressure ONLY. NEVER force the drill bit into
the work. This will overheat the tip and cause it to dull very quickly.
• When drilling in wood, clamp a piece of scrap wood to the
underside of the material to avoid splintering.
• ALWAYS drill directly in line with the bit. Do not use sideways
movement as this may damage the drill or cause the bit to break.
• Large holes should be drilled with wood augers, flat wood bits or
hole saws.
MAINTENANCE
Before any maintenance procedures, always ensure the drill is isolated from
the power supply by switching off and unplugging from the socket.
BEFORE USE
1. Inspect the power cable to ensure it is in good condition.
CLEANING
1. Ensure all air ventilation slots are clear of blockages, (use compressed air to
clean the machine if possible). Wear protective goggles if using
compressed air.
2. After use, clean all dust and swarf from the drill with a soft cleaning cloth.
Never use any chemicals/ solvents or harsh abrasives to clean the drill.
GENERAL MAINTENANCE
• All bearings etc, in this tool are lubricated with a sufficient amount of
high grade lubricant for the tools lifetime under normal operating
conditions, therefore no further lubrication is necessary.
• Refer to your CLARKE dealer if internal maintenance is required.
Summary of Contents for 6479504
Page 16: ......
